2N Plugin for XProtect Access integration

Version 1.7.0 (April 2026)

Summary:

Version 1.7.0 of the 2N Plugin for XProtect adds support for the 2N Force 2.0, 2N Access Unit QR and addresses some bugs.

Improvements:

    - Support for the 2N IP Force 2.0
    - Support for the 2N Access Unit QR
    - Resolves an issue where device icons were not correctly representing door state
    - Fixes an issue where lockdown and door hold state was not working correctly for 2N IP One

Requirements:

    - When second factor authentication (2FA) is enforced in Access Commander API bearer tokens must be used.
    - Milestone XProtect 2014 or newer (.net framework 4.5.1)
    - 2N Access Commander 3.6.0 or newer recommended.
    - Intercom/Access unit firmware 2.50.x/3.1.x

Note: Some older 2N devices cannot support versions higher than 2.50.x

Dependencies:

    - An enhanced integration license should be present in 2N IP Intercoms for correct functioning of this plugin. This license is not required for 2N Access Units.