Name Tags

1. A sheet of translucent foil is en closed to every device. Print it using a laser printer.

2. Cut the printed foil and insert the nametags in the buttons. Every name plate includes a piece of foil, which can be written over manually, using a waterproof permanent marker, if necessary.

   Tip

   Refer to the Support > Download Center section at 2N.com for the name tag printing template.

The advantage of 2N IP Force is its intuitive, simple access to name tags. There is no need to remove the front panel for replacement and so there is no risk of losing parts.

1. Loosen the name plate screw using the wrench enclosed, for example. You can open the name plate window like a door without losing the tightened screw.

2. Remove the used or blank name tag and insert a new tag.

3. Close the name plate window and tighten the screw appropriately.

4. Check the click effect of the button: if the button fails to click properly when pressed (when moved by approx. 0.5 mm), the tag is too thick or thin. Make sure that the button clicks when you press it on both ends.