Internal RFID Card Reader 13.56 MHz, NFC, OSDP
The 13.56 MHz Internal RFID Card Reader, NFC, OSDP (Part No. 9151023, 03229-001) is used for reading RFID card IDs in the 13.56 MHz band, NFC supported. Provides communication between a connected OSDP device (control panel, door controller) and 2N device via the OSDP.
Specification
Card Reader
Operating frequency: 13.56 MHz
Minimum reading distance: 30 mm above the 2N IP Force surface
Relay (SSR A, SSR B)
NO contact max. 30 V / 1 A AC/DC
Switched output
9.8 to 13.8 V DC according to power supply (PoE: 11.6 V; adapter: supply voltage minus 0,4 V), up to 400 mA
Logical inputs
Active mode – requires external voltage (jumper JP1 for IN1, pins 3–4 are open, jumper JP1 for IN2, pins 1–2 are open)
UIN-ON = min. +2.5 V
UIN-OFF = max. +1.5 V
UIN max. = +48 V
IIN (UIN +48 V) = max. 1 mA
Passive mode – requires external contact only (jumper JP1 for IN1, pins 3–4 are open, jumper JP1 for IN2, pins 1–2 are open)
UIN1 = approx. 8.3 V
UIN2 = approx. 8.3 V
ILOOP = approx. 0.5 mA
Signaling output
Internal red LED under the intercom front panel
Power Supply
For external RFID card reader
12 V DC ± 15% / 350 mA
OSDP Interface
OSDP reader (software configurable)
Recommended wiring
Module Settings
Refer to the Configuration Manual for OSDP, output and reader settings. Refer to the Automation manual for input, red LED and tamper switch settings and use.