Need help?

Select Your Region and Language

EMEA

AMER

Asia | Pacific | Australia

Brief Guidelines

Static/Dynamic IP Address Switching on Display

The DHCP mode switch resets all the System > Network parameters in the web configuration interface to defaults.

If the address is 0.0.0.0, then the device did not get the IP address from the DHCP server and the static IP address (DHCP OFF) has to be used. If DHCP OFF is set, the device static address is 192.168.1.100.

2N Sentrio Cabin:

To switch the DHCP on the device display, you must start the Hidden Menu:

  1. Wait until the end of the introductory animation on the display after starting/restarting the device.

  2. The moment the home screen appears (after approx. 20 s), place your finger in the left-hand upper corner of the display for approx. 5 s.

The IP address of the device will be shown in the Hidden menu. The menu contains the network mask, default gateway address and DHCP switch among others.

2N Sentrio Lobby:

  1. From the Dashboard, go to settings Six toothed gear, Settings Icon in 2N Sentrio Lobby.

  2. Go to Advanced Settings > Network Settings.

    Enter a code to access the Advanced settings. Set the Advanced settings access code in the web configuration interface (Hardware > Display > Advanced settings code > Advanced settings code).

  3. Activate/deactivate the option Use a DHCP server.

In this section:

Was this page helpful?