IP Address Retrieval
To retrieve the device IP address, take the following steps:
IP Address Retrieval Using 2N Network Scanner
The application helps you find the IP addresses of all the 2N devices in the LAN. Download 2N Network Scanner from the 2N.com website. Make sure that Microsoft .NET Framework 2.0 is installed for successful app installation.
Run the 2N Network Scanner installer.
The Installation Wizard will help you with the installation.
Having installed 2N Network Scanner, start the application using the Microsoft Windows Start menu.
Once started, the application begins to automatically search the LAN for all the 2N devices which have been DHCP/statically assigned IP addresses. These devices are then shown in a table.
Select the device to be configured and right-click it. SelectBrowse... to open the device administration web interface login box for configuration.
Caution
If the found device is grey highlighted, its IP address cannot be configured using this application. In that case, click Refresh to find the device again and check whether multicast is enabled in your network.
Tip
Double click the selected row in the 2N Network Scanner list to access the device web interface easily.
To change the device IP address, select Config and enter the required static IP address or activate DHCP.
The default login data are:
Username: Admin
Password: 2n
It is necessary to change the password immediately upon the first login.
Tip
It is recommended that a password is used that is difficult to break. It is not recommended that names, places or things, especially those closely related to the user, are used in the password.
For increased password security, it is recommended that:
the random password generator is used,
the password length is 12 characters at least,
various characters from different character sets are combined (small/capital letters, digits, special characters, etc.).
IP Address Retrieval Using Hardware
Follow the instructions below to retrieve the current IP address:
Press the button RESET and keep it pressed.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard
(approx. 15–35 s).
Release the RESET button.
The device announces the current IP address via the speaker automatically.
Note
The delay after pressing RESET till the first light and sound signaling is set to 15–35 s depending on the device model used.
IP Address Retrieval Using Speed Dial Button
Take the following steps to retrieve the 2N IP Verso IP address:
Connect the device to the power supply (if connected, disconnect and reconnect it).
Wait for the second sound signal.
Press the Quick dial button 5 times on the main unit.
The device reads its IP address.
Note
If the address is 0.0.0.0, it means that the device has not obtained the IP address from the DHCP server.
Press the button sequence within 30 seconds after the sound signal for security reasons. Up to 2 s intervals are allowed between the presses.