Mechanical Installation
This subsection provides the 2N Sentrio installation and connection instructions.
Installation Conditions
Make sure that the following 2N Sentrio installation conditions are met.
There must be enough space for the device installation.
Make sure that the depths of the dowel holes are accurate!
Before starting the mechanical installation on a selected place, make sure carefully that the preparations associated with it (drilling, wall cutting) cannot damage the electrical, gas, water and other existing wires and pipes.
The device is not designed for environments with increased vibrations such as means of transport, machine rooms and so on.
The device may not be exposed to aggressive gas, acid vapors, solvents, etc.
The device is not intended for direct connection into the Internet/WAN. The device must be connected to the Internet/WAN via a separating active network element (switch/router).
Avoid strong electromagnetic radiation on the installation site.
Caution
Exceeding the allowed operating temperature may not affect the device immediately but leads to premature ageing and lower reliability. For the acceptable range of operating temperatures and relative humidity values refer to S.Technical Parameters.
Any intentional mechanical damage to the device (drilling, main unit tampering, etc.) results in a loss of warranty.
The device installation and setting should only be performed by professionally qualified persons.
The installation and adjustment of this device, including any handling thereof, should only be carried out by persons qualified to do so.
Installation Conditions
Make sure that the following 2N Sentrio installation conditions are met.
There must be enough space for the device installation.
Make sure that the depths of the dowel holes are accurate!
Before starting the mechanical installation on a selected place, make sure carefully that the preparations associated with it (drilling, wall cutting) cannot damage the electrical, gas, water and other existing wires and pipes.
The device is not designed for environments with increased vibrations such as means of transport, machine rooms and so on.
The device may not be exposed to aggressive gas, acid vapors, solvents, etc.
The device is not intended for direct connection into the Internet/WAN. The device must be connected to the Internet/WAN via a separating active network element (switch/router).
Avoid strong electromagnetic radiation on the installation site.
Caution
Exceeding the allowed operating temperature may not affect the device immediately but leads to premature ageing and lower reliability. For the acceptable range of operating temperatures and relative humidity values refer to S.Technical Parameters.
Any intentional mechanical damage to the device (drilling, main unit tampering, etc.) results in a loss of warranty.
The device installation and setting should only be performed by professionally qualified persons.
The installation and adjustment of this device, including any handling thereof, should only be carried out by persons qualified to do so.