Calls
In this state, connection or connection attempt is in progress with another device. The 2N Indoor Talk functions are limited, it is impossible to switch to the home page and go to menus. Possible actions are included in the table below.
In this state, one of the following call types can be active in the device:
Outgoing call initiated by the 2N Indoor Talk answering unit.
Incoming trying to establish connection with the 2N Indoor Talk answering unit.
Active call – if connection between the devices is established, sound is transmitted.
Possible actions | Performance | Action result |
|---|---|---|
Incoming call receiving |
| Connection with the other device has been established, a call is in progress. NoteThe call receiving button flashes (green for 2N IP intercom/indoor answering unit incoming calls and blue for third party equipment incoming calls). |
End of Call |
| The outgoing call is cancelled./The incoming call is rejected./The active call is interrupted. |
Target device unlocking |
Short press | A code assigned to the short press of the unlock button is sent from the device. Set the code in the web configuration interface, in the settings for the specific contact in the Directory under . If no unlock code is set, the default unlock code is sent to the target device. Door unlocking is signaled by a tone and green flash of the lock button. |
Long press | A code assigned to the long press of the unlock button is sent from the device. Set the code in the web configuration interface, in the settings for the specific contact in the Directory under . If no unlock code is set, the default unlock code is sent to the target device. Door unlocking is signaled by a tone and green flash of the lock button. | |
Mute call |
| 2N Indoor Talk does not transmit audio to the called device. The microphone buttons is flashing yellow. The action reperformance cancels muting. |
Call volume control |
or
| A change is signaled by a beep. |
