Device Templates
The Device Templates function helps you configure multiple devices. The templates simplify initial system installation and unify settings across projects.
The templates work on the principle of pattern. The templates help you save the entire configuration of any 2N OS device or just selected configuration parts and apply the configuration to other devices. The configuration can be based on a device already configured, a device backup or a template previously exported.
While creating a template, you can choose which parts of the configuration are to be included. The components vary according to the device type (e.g. relay settings, audio outputs, automation). This selection is part of the template creating process and cannot be changed after saving.
Note
Using templates significantly reduces the initial commissioning time of the device.
Template Creation and Management
Go to Device > Templates to access the template function.
Click .
The Create Template dialog opens.
Select an existing device from the Device* pop-up menu to be the basic device for your template. Only template compatible devices will be displayed.
Click to continue configuring the template.
Caution
Warnings may appear for some configurations. They inform that selected configurations may have limitations or potential risks. The selection is still possible, but it is recommended that you check the notification.
If you already have a template or device backup saved in a file, you can easily import it:
Go to Devices > Templates.
Click at the top right.
Select the template/backup file from your PC and click .
Note
Some sections may show as deactivated during import. They include the configuration parts that could cause unintentional changes or impair the device function. These sections are automatically removed upon import and can be seen briefly by the user while loading.
Template Modification
The template can be modified after creation. The interface only displays the configuration parts that were included in the template creation.
Go to Devices > Templates.
Select a template from the list.
Click .
A dialog with the configuration sections is displayed.
Double-click a value to edit it.
The modified item is marked as changed immediately.
The
warning icon indicates the values that may not be fully validated on the device.
Caution
The validation performed at the template modification is for guidance only and is performed at the item level. The check does not capture all conflicts across devices and firmware versions and does not match the full validation process performed on 2N OS.
An item marked with a warning may still be usable on the device and, on the contrary, an item without a warning may be rejected during application. The real evaluation takes place on the device.
Apply Template to Device
A template can be applied to one or more devices. It can also be applied using bulk actions in the device list or directly from the device detail.
Go to Devices > Templates.
Select the template to be applied to the device.
Click .
Select a device and confirm.
The configuration list is displayed. These sections correspond to the selections made during template creation, but can be modified.
Click .
Caution
A warning is displayed if a discrepancy between the firmware version or device type for which the template was created and the target device version/type is detected during the template application. Non-compliance must be confirmed before proceeding.
Note
The state only confirms that the process has started successfully. It does not provide information on the actual progress or completion of the application.
Refer to Adding Device for the instructions for use of a template while adding a device.