Name Tags
A sheet of translucent foil is en closed to every device. Print it using a laser printer.
Cut the printed foil into individual labels.
Tip
Refer to the Support > Download Center section at 2N.com for the name tag printing template.
1 button: 52.0 (W) x 15.2 (H) mm (dimensional tolerance: +0; −0.5 mm)
5-button: 57.5 (W) x 89.0 (H) mm (dimensional tolerance: +0; −0.5 mm)
Infopanel module nametag sizes: 69.2 (W) x 86.7 (H) mm (dimensional tolerance: +0; - 0.5 mm).
Caution
The area where the name tags are located is a so-called wet zone. It is because water may get onto the film during heavy rainfalls. Water in this area does not affect the function of the device and evaporates spontaneously.
Always use waterproof foil (enclosed or other) for the nametags. Never use paper to avoid damage due to water leakage! Never use ink jet printing for the same reason!
Remove the module frame.
Lift up the button door. Lift up the button door for all the buttons on the 5-button module.
Remove the used nametag and insert a new one.
Close the button door.
Replace the module frame.
Fit the flush mounting frame top and bottom with screws.
Hitch the surface mounting frame on the hook on top and screw it in the bottom.
The advantage of 2N IP Verso is its intuitive, simple access to name tags. There is no need to remove the front panel for replacement and so there is no risk of losing parts.
Loosen the name plate screw using the wrench enclosed, for example. You can open the name plate window like a door without losing the tightened screw.
Remove the used or blank name tag and insert a new tag.
Close the name plate window and tighten the screw appropriately.
Check the click effect of the button: if the button fails to click properly when pressed (when moved by approx. 0.5 mm), the tag is too thick or thin. Make sure that the button clicks when you press it on both ends.