A) 2N Network Scanner

• Use 2N Network Scanner which can be downloaded here.

• If 2N Network Scanner can not find desired 2N Access Unit then:

1. the device can have static IP address from different IP address pool than your network

2. the device can be placed behind the router or firewall

3. there can be some troubles with you router (check IP address pool, firewall, DHCP server, etc)

• 2N Access Unit is equipped with a RESET button. Follow the instructions below to identify the current IP address:

B) Hardware Procedure

1. Press and hold the RESET button.
2. Wait for the device do beep once (both the red and green LEDs will light up simultaneously)

3. Release the RESET button.

4. The device announces the current IP address via the speaker automatically.

5. If the address is 0.0.0.0, it means that the device has not obtained the IP address from the DHCP server.

   This procedure can be applied to:

   • 2N Access Unit

   • 2N Access Unit 2.0

   • 2N Access Unit M

   This procedure does not apply to 2N Access Unit QR

    

2N Access Unit

Access Unit 2.0 

Access Unit M

1. Press the button shortly (< 1 s) to restart the system without changing configuration.

2.  Proceed with steps mentioned above