Call Connection
To make calls with other terminal devices in IP networks, it is necessary to assign the device to a contact in the Directory.
Make sure that Local calls is enabled on both the 2N devices.
Click above the table. Check the listed device that you want to establish connection to. Once the device is added, editing becomes available.
Edit the following:
a virtual number to start a call by entering the number via your numerical keypad
basic information and access options for the device user
To dial calls using a device button, assign the selected user to the speed dial button in , refer to Speed dial buttons.
Make sure that Local calls is enabled on the called 2N device to make a successful call.
Click or open the existing contact detail to create a new contact.
Click the pencil icon next to the Phone number
to open phone number editing.Enter the calling destination address into the destination field to which the call is to be routed. Complete the target IP address or SIP URI in the format “ user_name@host” (e.g.: “[email protected]” or “[email protected]”). For local calls, fill in the called 2N device ID as specified in the Local calls tab in the called device web configuration interface.
Edit the following:
a virtual number to start a call by entering the number via your numerical keypad
basic information and access options for the device user
To dial calls using a device button, assign the selected user to the speed dial button in , refer to Speed dial buttons.
Make sure that the call transmitting service is enabled on the called 2N device to make a successful call.
Tip
Each user can be assigned up to 3 phone numbers. In case the first user fails to answer, the call is forwarded to the next number. Alternatively, you can set calling to multiple phone numbers simultaneously. Check Call in group between the selected numbers to set such multiple phone number calling for one user.
In case all the user phone numbers are unavailable, you can set call forwarding to Deputy.
Users can be gathered in calling groups. The calling group name is shown in the phone book on the device display. You can assign a calling group to a quick dial button. To terminate an outgoing group call after the first rejection from any of the called users, set this function in Calls > General Settings.