The 2N Network Scanner is a simple, freely available application for locating 2N devices in the network. After searching the network, the application shows the type, firmware version and IP address of all intercoms found on a chart. This simplifies the administration and installation of intercom systems. 

Prerequisites

• A computer with Windows / MacOS operating system
  
  
• Supported 2N devices
  • 2N Access Commander
  • 2N Access Units
  • 2N Answering units
  • 2N IP Intercoms
  • 2N LiftIP units (not for 2N Lift8)
  • 2N SIP Speakers

Installation of 2N Network Scanner

• Download application from the product page and install it.

Locating 2N devices

• After you run the software, it will scan connected networks and provide you with list of detected 2N devices.

• If you need to rescan connected networks, please click on File - Refresh.

Or by right clicking on one device and choosing the Refresh option.

Changing IP settings of a detected 2N device

• Right click on the device and choose the Config option.
  If the device is grayed out and you can´t see the Config option,
  then the device does not support changing IP settings via 2N Network Scanner.

• In configuration, you can change between DHCP and static IP settings.
  You need to confirm changes by entering a password used for the Admin user.

Browsing the web configuration of the device

• Double click on the detected device to browse its web configuration.

Or by right clicking on the device and choosing the Browse... option.

Filtering search results

• You have the option to filter search results by typing into the filter box.
  You can filter for IP address, serial number, display name or firmware version.