Device Configuration
Connect the device to your PC via a LAN cable to configure the main unit. DHCP is enabled by default. Enter IP address 192.168.1.1 into your web browser (Edge, Firefox, Chrome) to get access to the web interface of the device. Enter admin as the user name and 2n as the password for the first login. Having been logged in to the web interface, you will be invited to change the default password.
Warning
For device security and access management, it is recommended that you always maintain the most up-to-date FW version to access the latest security patches and enhancements. Ignoring updates may increase the risk of security problems.
The new password should contain 8 characters at least including 1 capital letter, 1 small letter and 1 digit.
The password change will be required again after the main unit is factory reset.
A new password will be requested for the next login.
There are 3 tabs on the left side of the home page upper bar. The State tab shows basic information on the main unit (device ID, time data). Configuration helps set the main unit according to the user requirements. Maintenance is used for configuration and firmware maintenance, helps back up and refresh all settings, upgrade firmware and/or reset all parameters.
Switch the language versions of the main unit web interface on the right side of the home page upper bar. 7 languages are available (EN, CZ, DE, FR, ES, IT and RU). The item to the very right shows the logged-in user status (Admin, Guest).
A 10-minute idle timeout is followed by an automatic logout from the main unit web interface.
Warning
Press Ctrl + F5 to refresh the page if the web is displayed poorly in the Edge or Chrome browser.
Tip
Use 2N Elevator Center, a licensed cloud service, for the main unit remote management. Ask your distributor to create the service access data for you. Refer to www.2n.com for more details on 2N Elevator Center.