Internal RFID card readers
Internal RFID card readers are designed for mounting into the 2N IP Forcemain unit and is compatible with the main unit Part Nos. 9151101RPW, 9151101CHRPW, 9151102RW and 9151102CHRW. These models have a window, which is necessary for antenna operation. If the Internal RFID Card Reader is installed, it is not possible to install an Additional Switch.
The 2N IP Force Internal RFID Card Reader adds two logical inputs, two switches and a tamper switch to the main unit.
The purpose of the tamper switch is to signal any unauthorized opening of the device (to prevent a theft, e.g.). It is recommended to use the tamper switch.
Installation
 |  |
 |
Turn off the device.
Remove the front panel (7) from the device.
Mount the antenna board (8). Use the two enclosed screws (9).
Plug the enclosed cable (11) to the antenna board connector.
Demount the button PCB (1). Do not disconnect its cable!
Dismount the right-hand bottom spacer (there are four spacers altogether).
There are two short plastic spacers enclosed to the induction loop. Take the shorter, 6,5 mm long spacer. Screw it into the free hole on the motherboard.
Plug the enclosed plastic support (6) into the reader board from the bottom side.
Put the reader board (4) in the motherboard connector. Make sure that the screw hole is directly above the spacer.
Screw in the remaining metal spacer (3), which is 10.5 mm long.
Fit the button PCB (1) back to its position using the original screws.
If you want to use the tamper switch (to detect unauthorized case opening for theft protection), insert the tamper board (10) in the connector located in the right-hand bottom part of the switch board (4). As the tamper switch shares the Relay2 NO and NC terminals, you cannot use the RELAY2 output and the tamper switch at the same time.
Plug the antenna cable (11) to its connector at the reader board (4).
Replace the front panel and tighten all the four screws.