Technical Parameters
Power supply types | |
|---|---|
PoE | IEEE PoE 802.3af (Class 0, max. 12.95 W) |
External supply | 12 V ±15 % / 2 A DC |
Warning
2N IP Solo cannot be fed from an external power supply and PoE at the same time. A combined supply might result in a device damage.
Signaling protocol | |
|---|---|
SIP | UDP, TCP, TLS |
Audio | |
|---|---|
Microphone | Integrated |
Amplifier | 2 W (class D) |
Speaker | 2 W / 8 Ω |
Sound pressure level (SPL max) | 71 dB (for 1 kHz, distance 1 m) |
LINE OUT | 1 VRMS / 600 Ω |
Volume Control | Adjustable with automatic adaptive mode |
Full duplex | Yes (AEC) |
Audio stream | |
|---|---|
Protocols |
|
Codecs and Used Bandwidth |
|
Camera | |
|---|---|
Sensor | 1/3'' color CMOS |
JPEG resolution | Up to 1280 x 960 |
Video resolution | 640 x 480 |
Frame rate | 30 fps |
Sensor sensitivity | 5.6 V/lux-sec (550 nm) |
Viewing angle | 128 ° (H), 95 ° (V), 134 ° (D) |
Infrared illumination | Yes |
Sensor sensitivity without IR light | 0.1 Lux ± 20 % |
Focal length | 2.25 mm |
Video stream | |
|---|---|
Protocols |
|
Video call codecs |
Set the video codec data flows in for calls and in for streaming. The set bit rate represents the value that the codec has to approach on a long-time average. The data flow can vary depending on the scene to be scanned. |
ONVIF/RTSP streaming codecs |
|
IP Camera Function | Yes – compatible profiles:
|
Bandwidth used | |
|---|---|
Audio codecs |
|
Video Codecs | Set the video codec data flows for calls in . Set streaming in . The set bit rate represents the value that the codec has to approach on a long-time average. The data flow can vary depending on the scene to be scanned. |
Interface | |
|---|---|
LAN | 10/100BASE-TX with Auto-MDIX, RJ-45 |
Recommended cabling | Cat-5e or higher |
Supported protocols | SIP2.0, DHCP opt. 66, SMTP, 802.1x, RTSP, RTP, TFTP, HTTP, HTTPS, Syslog, ONVIF |
Passive switch (relay) | NO/NC contact, up to 30 V / 1 A AC/DC |
Mechanical Parameters | ||
|---|---|---|
Body material | Versions:
| |
Surface installation dimensions | One-module | 107 x 130 x 28 mm |
Flush installation dimensions | Frame – one-module | 130 x 153 x 5 mm |
Box (minimum wall hole) – one-module | 108 x 131 x 45 mm | |
Weight | max. netto 1 kg | |
Operating temperature | −40 °C to 60 °C | |
Relative humidity | 10 to 95 % (non-condensing) | |
Storing temperature | −40 °C to 70 °C | |
Protection class | IP54 | |
Resistance level | IK08 | |