Need help?

Select Your Region and Language

EMEA

AMER

APAC

Web configuration interface

Note

Each configuration change requires saving or restarting the device. Fields with invalid values are marked in red. Changes with invalid values cannot be saved. A change will not be set unless saved.

Device Configuration Interface Access

There are two ways how to log in to 2N EasyGate IP as described below.

Caution

  • We recommend using the 2N Elevator Center cloud service for the device security and data protection reasons.

2N Elevator Center

2N Elevator Center, a licensed cloud service, is used for remote management and access to the 2N EasyGate IP web interface. To create access data for the service, please contact your 2N sales representative or 2N distributor.

After the third unsuccessful login attempt, the user account will be blocked for one minute after the last attempt.

Never provide the 2N Elevator Center login credentials to other persons or services. Keep this information safe and do not enter it on unreliable websites.

Web Configuration Utility

You can configure 2N EasyGate IP without the use of the 2N Elevator Center cloud service by connecting the device to a PC via a USB cable using Easy Gate IP Web Configuration Utility, freely downloadable from 2N.com. EasyGate IP Web Configuration Utility is used for automatic opening of the web configuration page 2N EasyGate IP, which is connected via the local USB port.

Caution

Only one active USB connection is supported. If multiple devices are connected, leave only one 2N EasyGate IP device connected.

Installation

  1. Double-click the 2N_EasyGate_IP_Web_Configuration_Utility_Setup (.exe) file.

  2. Select the destination folder for installing the utility.

  3. Select other possible tasks – create desktop shortcut (optional).

  4. Confirm the installation.

  5. Click Finish to complete the installation.

Use

  1. Connect the power adapter to 2N EasyGate IP.

  2. Turn on 2N EasyGate IP.

  3. Connect 2N EasyGate IP to your computer using a USB cable (USB-A / USB-C).

    Caution

    Make sure the USB connection option is enabled, refer to System. Once the device is added to 2N Elevator Center, the USB connection option is automatically disabled.

  4. Open the installed application 2N EasyGate IP – Web Configuration Utility.

    • If 2N EasyGate IP is already connected via USB, its web page will be displayed automatically.

    • If 2N EasyGate IP is not connected at the moment, nothing will happen. To reopen the configuration web page, after a new USB connection or after a 2N EasyGate IP reboot, for example, you need to close and reopen 2N EasyGate IP – Web Configuration Utility.

  5. For your first login, enter “Admin” (admin is also accepted) for the username and “2n” for the password. After the third unsuccessful login attempt, the user account will be blocked for one minute from the last attempt.

  6. After logging into the web interface, you will be prompted to change the default password, otherwise you will not be allowed to change the configuration.

    Caution

    • To be compliant, your new password must be at least 8 characters long and contain at least one lower case letter, one upper case letter and one digit.

    • The password change will be required again after the main unit is factory reset.

In this section:

Was this page helpful?