Bluetooth Authentication
Make sure that the My2N app is installed in your mobile phone to make successful authentication via Bluetooth.
This process is secured by the Bluetooth trusted pairing mechanism. The pairing process varies depending on the firmware version of the device connected.
 |  |
Enter the pairing code into the My2N application to connect the application on the user’s phone to the 2N devices.
Get the pairing code as follows:
by connection with a 2N OS device
through a USB Bluetooth reader connected to your PC
Caution
Make sure that the device firmware version is 2.50 (or 3.0) and higher to achieve successful trusted pairing. If the device has an older firmware version, pairing will be made via an older mechanism using a PIN without a QR code.
Tip
Pairing via a QR code is recommended for higher security. If the QR code is unavailable or unsupported, use the PIN.
Download and install 2N IP USB Driver into your PC.
Make sure that the USB Bluetooth reader is enabled in .
Connect the USB Bluetooth reader to the PC.
Select My2N app authentication
in the user settings on the Credentials card.Select in the open dialog box.
The pairing code appears in the dialog box.
Follow the steps below for pairing in the application (My2N Mobile Application Pairing).
Make sure that
the pairing device is set for the given user’s company, refer to Company Settings;
the pairing device is located in the zone which the user is allowed to access, refer to Access Rules;
an adequate pairing time value is set, refer to Company Settings.
Select My2N app authentication
in the user settings on the Credentials card.Select in the open dialog box.
The generated pairing code is displayed on the card together with the remaining pairing time. Transfer the pairing code to the user. If the user’s e-mail address is completed, you can send the mobile key by clicking
.Follow the steps below for pairing in the application (My2N Mobile Application Pairing).
Download the My2N application to your mobile phone. The app is available at App Store and Google Play.
Open the My2N app and enter the pairing PIN.
Note
If the application displays a QR code yet the device uses firmware older than 2.50.0, pairing will be successful only if the PIN is entered.
Allow all the important authorizations to make My2N work properly.
Follow the instructions on your mobile phone – bring the phone close to the device in the pairing mode and click . Subsequently, the mobile phone starts searching a device for pairing.
Grant access to the selected mobile phone. Now you can open doors in the whole location.
Warning
Use the Mobile Key application for pairing of mobile phones with older OSs (Android 9 / iOS 17 and lower).
Download the Mobile Key application to your mobile phone. The app is available at App Store and Google Play.
Open the application and enable Bluetooth access for Mobile Key.
According to the mobile key type, draw your mobile phone near the USB reader or the pairing device.
Click the device offered for pairing in Mobile Key.
The application prompts you to enter the PIN code. Enter the pairing code and confirm.