2N IP Intercoms - IP Address retrieval

You have to know your intercom IP address to log in to the integrated web server. Upon purchase or factory reset, the device is set to the dynamic IP address mode – it retrieves the IP address automatically if there is a properly configured DHCP server in the LAN. If no DHCP is available, you can operate it in the static IP address mode. 

You can retrieve the IP address by our 2N^® Network Scanner 
2N® Network Scanner - Locating 2N devices in the network

Or you can let the intercom tell you the IP address by itself (guided in this article).

Prerequisities

• 2N IP Intercom connected to your local network.

• Possibility to reboot the device.

How to retrieve the IP address by the inbuilt speaker

• Reboot the 2N IP Intercom (disconnect it from the power supply and reconnect again)

• Once the device is booted (you can hear the second sound signal), do the specific procedure within 30 seconds described later for each IP intercom model. If you miss this time period, it is necessary to reboot the device again.

• 2N IP Intercom reads its IP address via its inbuilt speakers.
  If you hear 0.0.0.0, it means the intercom has not obtained the IP address from the DHCP server
  (DHCP server is not available, not presented in network or does not have any free IP address to assign).

Specific procedure for each IP intercom model

• 2N^® IP Vario
  • press 5x the quick dial button
    (versions with 3 or 6 buttons - use the middle quick dial button on the right side)
    
    

• 2N^® IP Force, 2N^® IP Safety
  • press 5x the first quick dial button
    
    

• 2N^® IP Verso, 2N^® IP Verso 2.0, 2N^® IP Solo
  • press 5x the quick dial button on the main unit

• 2N^® IP Base
  • press 5x the first quick dial button
    
    

• 2N^® IP Uni
  • press 5x the first quick dial button
    
    

• 2N^® IP One
• press 5x the quick dial button
  
         

• 2N^® IP Style
  • Wait until the end of the introductory animation on the display after starting/restarting the device.
    The moment the home screen appears (after approx. 20 s), place your finger in the left-hand upper corner of the display for approx. 5 s.
    
    

• 2N^® IP Audio, 2N^® Video Kit
  • press and hold the RESET button
  • wait until 1 beep is heard (the red and green LEDs go on simultaneously on the device, located between LAN connector and RESET button)
  • release the RESET button immediately