You can use our external USB RFID reader to add RFID cards/fobs to the 2N IP Intercom´s and 2N Access Unit´s users directly from your computer.
This guide will show you how to use this USB 125KHz RFID reader (9137420E).

If you have our USB 13.56MHz+125kHz RFID reader (9137421E/9137424E),
please follow another article below, because of necessary additional driver.
External USB readers - Driver installation & usage

Prerequisities

• 2N USB 125KHz RFID reader (9137420E)

• 2N IP intercom or 2N Access Unit with the latest firmware, equipped with 125 kHz RFID reader

• Optionally 2N Access Commander the latest version

• English keyboard in the computer system

Installation

To use the USB 125 kHz RFID reader, you do not need a specific driver.
It works similar to a keyboard, sending codes of top (row) numeric keyboard.
 

• Connect the USB reader to the USB port of your computer.

• Setup English keyboard in the system.

Reading 125 kHz RFID card

• 2N IP intercom or 2N Access Unit
  
  
  • Go to the web interface of the device, section Directory - Users - specific user - User Cards.
    
    
  • Click your mouse on the Card ID field. Make sure it is completely empty.
    
    
  • Swipe your RFID card over the USB reader (the code is automatically translated from DEC to HEX) and save.

• 2N Access Commander
  
  
  • Use your web browser to open the web configuration, go to Settings - Credentials section and enable the reader to use.

• In Users section add the RFID card to the user using connected USB reader.