2N® Access Unit 2.0 RFID 125 kHz
Order number: 02137-001
Do you have a project for modernising a house, including the access control? Do you want to remove the old controllers, simplify administration and at the same time allow residents to keep their old cards? Select our RFID reader for cards on a frequency of 125 kHz. You only need a UTP cable to connect it to the network and power supply. Forget about connecting with the controller. The unit is a smart device in its own right. Datasheets (US)
Technical Parameters
| Interfaces | |
| Power supply: | PoE and/or 12 V/1 A DC |
| PoE: | 802.3af (Class 0–12.95 W) |
| LAN: | 10/100BASE-TX with Auto-MDIX, RJ-45 modular jack |
| Recommended cabling: | Cat-5e or better |
| Active switch output: | 8 to 12 V DC/max 600 mA |
| Passive switch: | NO/NC contacts, up to 30 V/1 A AC/DC |
| Inputs: | 2 inputs - in passive/active mode (-30 V to +30 V DC) |
| OFF = open or Uin> 1.5 V | |
| ON = short-circuit or Uin< 1.5 V | |
| Tamper switch: | native part of the 2N Access Unit 2.0 |
| Audio: | buzzer (97dBA) |
| Supported protocols: | DHCP opt. 66, SMTP, TFTP, HTTP, HTTPS, Syslog |
| RFID Card Reader | |
| Supported frequencies: | 125 kHz variant |
| 125 kHz: | EM4100, EM4102, HID Prox |
| Mechanical Properties | |
| Frame: | robust zinc cast frame with surface finish (nickel and black color) |
| Operating temperature: | -40°F to +140°F |
| Storage temperature: | -40°F to +158°F |
| Operating relative humidity: | 10%-95% (non-condensing) |
| Dimensions: | Wall (surface) mounting frame: |
| - 1 module: 4.2 (W) x 5.11 (H) x 1.10 (D) inch | |
| Flush mounting frame: | |
| - 1 module: 5.11 (W) x 6.02 (H) x 0.19 (D) inch | |
| Flush mounting box (minimum hole): | |
| - 1 module: 4.25 (W) x 5.15 (H) x 1.77 (D) inch | |
| Weight: | max 1.76 pounds |
| Cover rating: | IP54 and IK08 |
Show more