2N® Access Unit M RFID Multifrequency
Order number: 02394-001
The unit reads cards at frequencies of 125 kHz and 13.56 MHz. This comes in handy if you have several companies in one building, each of them using different cards and they share certain areas. It also includes a controller with full decision intelligence. All you need to install and power the unit is a single UTP cable. The customer saves money on readers and you save time on installation and configuration. Datasheets (US)
Technical Parameters
Interfaces | |
Power supply: | PoE and/or 12 V/1 A DC |
PoE: | 802.3af (Class 0–12.95 W) |
LAN: | 10/100BASE-TX with Auto-MDIX, RJ-45 female (pigtail) |
Recommended cabling: | Cat-5e or better |
Active switch output: | 8 to 12 V DC/max 600 mA |
Passive switch: | NO/NC contacts, up to 30 V/1 A AC/DC |
Inputs: | 2 inputs - in passive/active mode (-30 V to +30 V DC) |
OFF = open or Uin> 1.5 V | |
ON = short-circuit or Uin< 1.5 V | |
Tamper switch: | native part of the 2N Access Unit M |
Audio: | buzzer, 1 W/8ohm |
Supported protocols: | DHCP opt. 66, SMTP, TFTP, HTTP, HTTPS, Syslog |
RFID Card Reader | |
Supported frequencies: | 13.56 MHz variant |
125 kHz and 13.56 MHz variant | |
125 kHz: | EM4100, EM4102 |
13.56 MHz: | ISO14443A, ISO14443B, NFC support |
reads UID (CSN) | |
Mechanical Properties | |
Cover: | tempered glass with durable plastic |
Operating temperature: | -40°F to + 140°F |
Storage temperature: | -40°F to +158°F |
Operating relative humidity: | 10%-95% (non-condensing) |
Dimensions (surface mounted): | 1.969 (W) x 5.236 (H) x 1.063 (D) inch |
Weight: | max 1,1 pounds |
Cover rating: | IP55 and IK07 |
Show more